Criterion 01: Updating control unit MIB 3 EI
Due to a SW fault in control unit MIB 3 EI, the sound volume of rear sensors may be too low.
Update procedure
• Using USB-C update the SW of MIB 3 El to the new SW version 1805
• SW 1805 can be downloaded using the program SD Creator where you enter the Part No. 5FMIB3EISW1805
• Update procedure MIB CU – see Service Information 2034053
• Always use USB-C in the manner specified in the Service Information 2034053 (Attachment 2).|
• Do not disconnect the charger during the update and do not interrupt the operation in any way (switching off the ignition, disconnecting the power supply, restart of the unit etc.)
Connect the diagnostic tool when you are asked to do so (to confirm the component update) – see Service Information 2034053.
•Using the diagnostic system ODIS Service update the control unit MIB 3 El, enter the measure code 367F to load the current parameters, coding, adjustment.
1.虚拟商品,一经购买,不接受任何形式的退款!如果不能接受以上协议请勿下单!
2.虚拟商品,不接受远程指导!如果不能接受以上协议请勿下单!
3.本站资源全部来自网络,如有侵犯你的权益请联系管理员,Email:admin@vwodis.com我们会第一时间进行审核删除。站内资源为网友个人学习或测试研究使用,未经原版权作者许可,禁止用于任何商业途径!请在下载24小时内删除!